Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Questionmark10
-
Dimension range in Sketch
Hi, thank you for the input John, sadly this is not exactly what i am seeking. I will try to explain a little better what im after. I have a sketch where i have to arrange a number of different objects to fit into a certain space. Some of them are on fixed possitions but for the most part I am...- Questionmark10
- Post #6
- Forum: Siemens: UG/NX
-
Dimension range in Sketch
Hi John, thank you for the prompt reply, however sad to hear that that is the only possibility. Regards- Questionmark10
- Post #3
- Forum: Siemens: UG/NX
-
Dimension range in Sketch
Hi, I was wondering if it is possible to add a dimension constraint to a sketch that allows for a range of values. I.E. i would like the minimum distance between two points to be no smaller than 25mm. Is there a possibility to do this with NX9? It is needed in the early stages of development...- Questionmark10
- Thread
- Replies: 5
- Forum: Siemens: UG/NX
