Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by qpublic

  1. qpublic

    Section cut for Catia V5 R9

    Thanks guys, I greatly appriciate this. The suggestions worked great. Best Regards.
  2. qpublic

    Section cut for Catia V5 R9

    Hello, I've got a v4 model imported into V5 and I"m trying to take just a half section of the part to work on. Is there a way to just take a half or a quarter section of the part to work with? I need to do some analysis and a helf section of the part will do just fine. Thanks in advance.
  3. qpublic

    Needed Public domain Catia V5 .CATPart files

    Hello All, Does anybody know where to find high quality and high complexity .CATPart files that are for general public usage for analysis purposes? Ie, Fuselage, Engine Manifolds, Rims, Landing gears, Engine blocks etc. I have used traceParts program but the parts are not complex enough or...
  4. qpublic

    creating solid part geometry from a surfaced part in V5

    Hello All, Thanks for your valuble input... and just to put the mystery to rest:) the box example was just so I can get started with something, the actual geometry is a lot more complicated. Thanks once again.
  5. qpublic

    creating solid part geometry from a surfaced part in V5

    Hello, I was looking more in terms of if you create a box(cube) using surface function under wireframe and surface module and then want to covert those 4 surfaces that create an enclosed volume into a solid part. Thanks in advance.
  6. qpublic

    creating solid part geometry from a surfaced part in V5

    Hello, I've done this once before but for the life of me I can't seemed to remember how to transform a surfaced part into a solid part in Catia V5R9 within Wireframe and Surface design module. Thanks.
See more

Part and Inventory Search

Back
Top