Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by QEnewbie
-
Casting tolerance within...
Hey all, I'm looking for some advice on how to interpret a note on a drawing. It has casting and machined features toleranced. In the title block their is not a reference to .xx place decimals for tolerancing. However a note on the drawing states "CAST FEATURES SHALL BE LOCATED WITHIN .03 OF...- QEnewbie
- Thread
- Replies: 1
- Forum: QC, Inspection & Testing engineering
