Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by PutrandaXY

  1. PutrandaXY

    The Plastic Strain at First Yield Must Be Zero

    What is UTS? The only data I have from the experiment is the yield strength which 350 MPa. In order to define the material properties in ABAQUS, I use Eurocode model as suggested by my corresponding researchers. Actually I'm doing thermal analysis. And the reason it is perfectly yield is...
  2. PutrandaXY

    The Plastic Strain at First Yield Must Be Zero

    I am not 100% sure what you mean. This is what I have done so far. I hope you can check this for me. ELASTIC Elastic Modulus Poisson ratio 210000 0.3 PLASTIC Stress Strain Plastic Strain 350 0.0017 0.0000 350 0.0018 0.0001 350 0.0020 0.0003 350 0.0040 0.0023 350 0.0060 0.0043...
  3. PutrandaXY

    The Plastic Strain at First Yield Must Be Zero

    Hi there. I am validating an experiment test using ABAQUS. However, the only data available from the experiment is YIELD STRENGTH which is equal to 350 MPa. According to Eurocode, at this point, the YIELD STRAIN = 0.02 So I entered the data on ABAQUS as it is (YIELD STRESS=350, YIELD...
See more

Part and Inventory Search

Back
Top Bottom