Hello All,
I have a situation where mating parts do not match. The assembly is a spinning rotor. The tapers should be equal but the male is 16.6 degrees and the female is 16.3 degrees. This is a legacy problem that I have inherited. I looked up a chart for sizing tapers but it listed crazy...
I would have done that, but I did not model this POS. It was done by another engineer who is long gone from the company. I don't want to have to redo all of the drawings. The SolidWorks video I watched shows how to copy a body by checking the copy check box, my display does not have that option...
As I said, I am pretty rusty with SolidWorks. The file I am working with is a welded frame with sheet metal brackets. I need to add additional fasteners. It cannot be a pattern because they need to be located on a different face. The file is a .SLDPRT. I need to add 90860A111_ROUND BASE WELD...
Hello All,
I am working with an weldment/sheet metal part that I inherited. I need to copy some fasteners, but when I invoke the copy body command there is no option for copy only move.
It has been a while since I have used SolidWorks, I have just gotten off the Inventor train so I am a little...
If understand correctly, you are trying to pump out a chamber that contains perlite. If that is so you could pump on that for days and never get down to a good vacuum suitable for leak testing. The perlite is acting as a sponge for air molecules as well as other gasses. These constitute a...
