Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by PratikG
-
Contradicting drawing callouts
Hello Everyone, Please find attached screenshot of a stamping part. We are making a frameplate and there are two emboss on datumA. The flatness callout on DatumA is 0.3mm whereas the profile callout on the emboss is 0.1 to A,B and C. Is it possible to achieve the profile of 0.1mm of the emboss...- PratikG
- Thread
- Replies: 3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
