Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by prabhakardesign

  1. prabhakardesign

    GD&T Book for DIN ISO standards

    Hello, Iam working in Germany, in our organisation DIN ISO standards are used. For GD&T we have to refer many standards liske ISO 1101, ISO 8015, etc., Please advice me a Book which contains all the GD&T standards for DIN ISO(In English version). Thanks in Advance Prabhakar
  2. prabhakardesign

    Can True profile dimension be outside the Profile tolerance zone

    Thank you very much, for providing the valuable suggestions. I conclude that (as of now), it is not possible to use Profile Tolerance for which the True profile dimn is outside the tolerance zone. Profile tolerance can be unidirectional when True profile lies in upper or lower limit of the...
  3. prabhakardesign

    Can True profile dimension be outside the Profile tolerance zone

    Hello, Wether Profile tolerance can be given to a surface, for which the Basic dimension should be outside the profile tolerance zone. For a size dimension 50 +2/+1 can we provide unilateral profile tolerance. The mean value is 51.5, and nominal value is 50 (Upperlimit is 52 and lower limit...
See more

Part and Inventory Search

Back
Top Bottom