Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by postmac

  1. postmac

    arc length dimension

    In an IDW you can dimension it. In an IPT (which you are in due to the options you described from a right click) you can use the formula for arc length (Angle*rad*pi/180) as a custom Parameter if you dimension the radius and the angle of your arc. Otherwise there is not an arc length dimension.
  2. postmac

    Helix......

    Check out thread: http://discussion.autodesk.com/thread.jspa?messageID=4374431
  3. postmac

    Crash when deleting drawing view with ordinate dims's, I9 sp4

    When I delete a view in a drawing with an "ordinate dimension set" Inventor crashes. Can someone duplicate this?
See more

Part and Inventory Search

Back
Top Bottom