Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by PN65
-
Guidance for Project
Hi Greg, I'm not asking anyone, certainly not you in particular to do my homework! I told the solution I was planning on implementing on my project. I was asking for expert opinion before submitting. I thought that's what this forum was meant for! And what is so particularly inane about the...- PN65
- Post #3
- Forum: Student Engineer General Discussion
-
Guidance for Project
Project Steps: I will be given a drawing to make a mould for producing rubber cones. I will produce the mould and the rubber cone. I will then be told that there is an error with the original drawing,and that the rubber cone should actually have a neck at the smaller diameter end. (attached...- PN65
- Thread
- Replies: 4
- Forum: Student Engineer General Discussion
