Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by pm3000
-
Applying bearing constraints "2"
Hi, i am trying to applay bearing constraints as in JohnAndrews post in thread828-176845, but get an error: The geometrical references may be in a conflict with another constraint or dependent side of a rigid/weighted link. What am I doing wrong? Constraints were excluded in analysis.- pm3000
- Thread
- Replies: 0
- Forum: PTC: Creo Simulate (Pro/E Mechanica)
