Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by plasticguy78

  1. plasticguy78

    Cutting Platic PP or PVC

    Hello TRL1997, I am not sure of the application or if you need a specific size hole. But RainBird carries a hole coring tool to install saddle tee's into HDPE pipe. You can pick them up at local irrigation distributors. This product will not leave any material shavings or pieces behind...
  2. plasticguy78

    Structural Foam

    Does anyone know an approx industry rate range for a 1000 ton structural foam press?
  3. plasticguy78

    materials for 2 shot moulding

    Here is a chart that may help... http://www.masterprecision.com/pages/2shot/2shotmold5.html -David Velarde dvelarde@rainbird.com 626-812-3838
  4. plasticguy78

    multi-shot molder

    Do you have their contact info?
  5. plasticguy78

    multi-shot molder

    Does anyone have any experience with any good 2-shot or insert injection molders overseas that are inexpensive processors?
See more

Part and Inventory Search

Back
Top Bottom