Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by pkgEng

  1. pkgEng

    Forcing an angle dimension on near parallel lines?

    It is quite easy to dimension the angle... Just zoom in to a point that the two lines are separated far enough apart so that you can click between them to place the dimension. If the angle is very small, then you must zoom in quite a ways.
See more

Part and Inventory Search

Back
Top Bottom