Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Piping Hydro

  1. Piping Hydro

    Weld Neck Flanges

    Dear "LittleInch" , I offered my recommendation to use WNF, ASTM A707 instead of A105.
  2. Piping Hydro

    Weld Neck Flanges

    Thank you so much "LittleInch" Dear "DekDee" you are right the test pressure is based on design pressure, but we have to ensure that hoop stress will be produced from test pressure doesn't exceed 100% of SMYS at any point. Thank you for all sharing info.
  3. Piping Hydro

    Weld Neck Flanges

    Gents, we had already welding neck flange and a pipe with the same wall thickness but different yield strength as per above specs.
  4. Piping Hydro

    Weld Neck Flanges

    you are right the Min. SMYS of a105N is 36 KSA this is the min. required , but regarding to supplier certificate and after heat treatmeant it became 52 KSI , doesn't matter! I think there is no problem to weld the pipe and flange together taking in consideration the difference between two yield...
  5. Piping Hydro

    Weld Neck Flanges

    Thanks for your kind response "LittleInch" , be noted the pipe has the same thickness of WNF (0.81")but they have different yield strength and as per material specs. certificate from supplier of WNF its yield strength is 363 MPa (~ 52 KSI) but the yield strength for pipe is 70 KSI , so the hub...
  6. Piping Hydro

    Weld Neck Flanges

    If we intend to use weld neck flange 56" , 600# , THK. 0.81" (ASTM A105N) with pipe 56" , API 5L , X70 , THK. 0.81" , is it applicable to weld them together and what is the precautions shall be taken in our considerations for this issue including welding , NDT and hydro static testing? Note...
  7. Piping Hydro

    golden weld

    internal coating for golden weld joint
  8. Piping Hydro

    golden weld

    thanks Pennpiper [smile] I meant, Is there a solution for internal coating of golden weld or I try to get another way to hydrotest the branches with main pipeline to overcome the problem of internal coating of golden weld .
  9. Piping Hydro

    golden weld

    Dears, Is it possible to create "golden weld" for internal coating pipeline after hydrostatic testing, and what's the technique used for coating "golden weld" ? note: we have main pipeline 20" and two branches 12" , where each pipeline will be hydrostatic tested separately and then two...
See more

Part and Inventory Search

Back
Top