Alright, I can't believe I need to ask this question, but I'm looking at the term in Bernoulli's equation for dynamic pressure (1/2*rho*velocity^2). Can someone explain to me the units on this this? When I look closely, it looks like it gives the answer as a unit of force, not pressure...
Howdy,
Does anyone know where I can find a stress strain curve for Al 6061-T4. I've been able to find 6061-T6 relatively easily, but T4 is giving me fits!
Thanks in advance!
PJF
"Secondly: This is a nightmare situation - for your boss. "
I agree. He is under a lot of pressure to prove than his assumptions won't matter in the long run. You know, no harm no foul. That worries me and I take everything he says with a grain of salt.
"Did you "follow" your boss' calcs...
My boss (stress analyst) has made several assumptions that have been flat out wrong. It appears to the rest of the team that these assumptions have been made in order to reduce our calculated stresses. Word of SOME (not all) of these assumptions have reached upper management and we've been...
The loads were provided to us through our loads department. I'm sure there is some conservatism in those estimates, but none of us really know how much.
The culprit in question here is non-aged, non post heat treated, al 6061-t6.
Thank you again for your suggestions. I know we had...
You are starting to open the same can of worms that I have on my desk.
Q: Where are you getting the Kt to divide by?
A: That's the $64,000 dollar question around here. There is no definitive answer for that question.
Q: Have you checked your model for consistent units / correct BCs / etc...
Q: Is the static load due to pressure only? What does it simulate? An ultimate load case or a service load or the proof test load?
A: No, but pressure is the biggest contributor. If I don't divide by the Kt, the part shows stresses higher than yield in almost every load case.
Q: Are you...
Yes, it is worrisome, which is why I think I need some direction/encouragement. My background is that I've recently graduated from college with masters in mech eng, with no real industrial FEM experience, no real stress experience, but I’m concerned about the corporate trend of just pushing...
"Always ask yourself "what am I trying to accomplish / what question am I trying to answer with this FEA?""
That's a difficult question to answer without test data...how do I know what the failure mode is? I'd like to know if I should be concerned about static loading (high loads) on the...
