Hi Timothy2, WELDING IS REQUIRED BECAUSE WE ARE REPLACING MISSING MATERIAL REMOVED DUE TO CORROSION IN LOCALIZED AREAS. SINCE THESE ARE COMMERCIAL AIRCRAFT PARTS, WE MUST RESTORE AT A MINIMUM, THE ORIGINAL OR GREATER STRENGTH AND MAINTAIN OEM DESIGN DIMENSIONAL TOLERANCES TO THESES AREAS. THERE...
Scott,
No, I am not Phil Condit and I'm located in Shelton, Washington.
I'm trying to perform weld repairs on magnesium krueger (leading edge) Flaps for 727's.
I have Boeing approval for my welding procedures and have been working very close with Boeing service engineering on this. Together...
Is anyone out there qualified or know someone qualified to weld magnesium per Boeing spec BAC5975 using filler rods ER AZ92A or R AZ92A per AWS A5.19?
We have about 10 projects that need this done and are unable to find a qualified welding vendor ANYWHERE.
Thank you
I am attempting to repair some impact damaged screw bosses on a cast aluminum valve actuator housing by building up the damaged bosses by welding, machining back to design dimensions and re-installing the helicoil inserts. I sent this housing to the lab for material analysis and was informed it...
