Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by phil14

  1. phil14

    what is the best way to handle center punches on a sheetmetal part

    I am wondering what would be the best way to handle calling out center punches on a sheetmetal part. Right now we are just creating holes of .200 diameter on the part where there will be center punches. This results in a drawing with hundred of tiny holes in it, and often times, it creates a...
See more

Part and Inventory Search

Back
Top Bottom