Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by petrabb
-
Plastic capacity of beam
A cantilever beam develops a fully plastic cross section at its base due to high bending moment. The cross section is rectangular, so the upper half will be in tension, the lower in compression with stresses equal to yield. What happens if I then apply an axial load (e.g. tension)? My guess...- petrabb
- Thread
- Replies: 9
- Forum: Structural engineering general discussion
