Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by pete64

  1. pete64

    3d Quick Press

    Is any one out there designing dies with 3d quickpress? We have had it for about a year and are trying to get comfortable to design a die in it. I am almost to the point but am having a hard time making prints. I have templates for our current 2010 SW but can not get the bill of materials to...
  2. pete64

    Engraving Font

    That font does not put the letters at the same height due to the spacing of the lines are not equal. Thanks anyway
  3. pete64

    Engraving Font

    Is there a TT font out there that has double lines that are equally spaced so you can extrude, or cut with taper to a single center line. I have used the camworks font, but it is not saved in the model. If a cut cut or extrude could be done to a point, it would be on the model and the geometry...
See more

Part and Inventory Search

Back
Top