Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Percy99504

  1. Percy99504

    ASME Allowable Stress - Safety Factors

    Thanks for your replies BI & Met. Your information was helpful!
  2. Percy99504

    ASME Allowable Stress - Safety Factors

    Thanks for your reply! I am not talking about strength reduction or joint factors. I am referring to B31.4 402.3 "Allowable Stresses" which is given as .72. We use this for B31.4 MAWP calculations. For B31.3 we use .5, .6, or can use .72 with engineer approval. But I do not see a similar...
  3. Percy99504

    ASME Allowable Stress - Safety Factors

    B31.4 clearly states use of safety factor of .72. For B31.3, we use .5 and .6, but I cannot locate references to these factors in the code. Do you know where they are referenced and shown?
See more

Part and Inventory Search

Back
Top