Recent content by peppinu

Danfoss has 8 service thermostats. Can you suggest one of them please? I am not sure about active and passive signal. Thanks

Circuit diagramhttps://files.engineering.com/getfile.aspx?folder=1d024b73-91a6-4c58-b930-8b9ba241be53&file=CD.pdf

Thanks Keith. I have uploaded the files again. It seems only one file can be uploaded. Yes you are right about the image showing one compressor. If you go through the pages you see that there are two thermostats. Could it be that both of them are the same? On the circuit diagram there are two...

Hi everyone, I do not know if I am in the right place asking this question. My fridge/freezer is quite old, it has two compressors for the fridge and for the freezer and therefore two thermostats. Both compressors work very well and it is still in great shape. My freezer thermostat became...

You can paste them with reference and when you are done you can "collapse" them. Collapse is a command under model tab, editing, in creo4. However if you have family tables it seems collapse is greyed out.

Most probably you created a rough stl file. I find best initially to put "chord height" to zero and accept the default when hitting the enter key. The lowest value us applied and this depends on the accuracy of the file. Id the model has lower accuracy the chord height comes small and in turn...

We have been using sla for quite a time. We always bought resin from 3DSystems. Can someone tell me who are the other sla resin suppliers and a word about their resins?

Once I got a part from a person and I suspected that it came from an illegal version. When I opened the file with wordpad at some point in the header, just after the version instead of "by parametric Corporation" there was something else. If you open the part in proe and save it will disappear...

Thanks Arunmrao, but this software seems that it is compatible only with 3D printers. I am looking for an sla slicer that can output 3DSystems' Viper compatible files: .BFF

Thanks Dan. I understand that it has to be a third party and against a premium but does it exist?

We are using 3D Lightyear from 3D Systems to prepare files for building on a Viper. Does anyone know if there is an alternate software for this? Thanks

Thanks to both of you. I was once led to believe that wf4 could not use all CPU cores whilst creo 3 makes use of multiple cores. I reasoned out that provided the hardware is decent (Fujistu with xeon @ 2.8Ghz with Quadro k2000) creo would perform better on the same hardware, compared to wf4.

We are in the process of upgrading. Does CREO 3 perform better than WF 4 with the same hardware?

We are trying to implement MoselCheck. I was hunting for a good book and it seems there isn't much out there. I found "Re-Use Your CAD: The ModelCHECK Handbook" and we are going to buy it. Has anyone got this book? Any comments about it?

We would like exchange some data from Creo 2 to NX. In Wildfire there is such a thing as ATB which will update an imported Neutral imported feature if the original neutral file is update. Does anyone know if there some function in NX that would enable to update the NX part without having to...