Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by PCB4U

  1. PCB4U

    Half Shear (lance form) in V20

    I am trying tp create a half shear in Solid Edge so I can run wires through them. I'm running V20 and apparently there is no direct function to do. There is a lance for a louver but that would not restrain the wires. Any ideas? Thanks Jay pcb4u at verizon dot net
  2. PCB4U

    PURCHASE SOLID EDGE?

    Thanks so much for the response. I'm located in So CAL and waiting for the CD from the reseller to try SE for 30 days.
  3. PCB4U

    PURCHASE SOLID EDGE?

    I am looking for opinions on Solid Edge (V18 soon V19). I am new to 3D and taught myself Catia at work. I consider myself an OK user of Catia where I can draft, constrain, assemble, etc. I didn't get into surfaces and contouring as I didn't need to do that type of assemblies. Being an EE...
See more

Part and Inventory Search

Back
Top Bottom