Recent content by Pavel Zemanec

Dear all, many thanks for your helpful tips and advices! I really appriciate it! We will try to think about the rotary die :-)

Germany... Customer is customer :-) ... They want to have automatical unrolling system for fabric (it is in 15cm width roll) connected with automatical cutting of shapes...

It is a serial production... Around 450.000 pcs in the next 3-4 years... Cycle time is not a problem - 1 piece/20 s...

Accurancy +/-2mm is not a problem...

Dear all, thank you very much for your tips. It is synthetic material and 0,1mm is not the accuracy, it is thickness of the material. The material doesn´t have to be cutted in more layers, one layer is enough because the cycle time can be arround 20s/piece. The hot die cut sounds really good...

Unfortunatelly the die cutting was not working properly because of the burrs etc. Just as an information the material is in 150 mm wide roll and the cutting system will also be connected with unrolling system for the input material - fabrics.

Dear all, I would like to ask you for your help / tips. We have very simple task but unfortunatelly limited budget :-( We would need to cut from very thin textile (0,1mm) two simple shapes - see attached drawings and pictures. Required cycle time: max. 30 s / 1 cutted piece. We tested CO2...