Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Paul Guilford
-
Relief Valve Discharge Pressure Testing
Thanks for that I agree the pressure test should have been done before the weep hole was put in to strength test the pipe. The Guideline 1/42 is from the Pressure Equipment Directive Guideline Number 1/42. Link: https://ec.europa.eu/growth/sectors/pressure-gas/pressure-equipment/guidelines_en...- Paul Guilford
- Post #3
- Forum: ASME (mechanical) Code Issues
-
Relief Valve Discharge Pressure Testing
I am currently designing to ASME B31.3 and have been asked about pressure testing Relief Valve Discharge Pipes. ASME states that Vents and drains need not be pressure tested post the last valve but as they are covered under the PED and classed as being in the scope of PED if the discharge...- Paul Guilford
- Thread
- Replies: 4
- Forum: ASME (mechanical) Code Issues
