Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by paragon40

  1. paragon40

    Lathe Fanuc Post Question?

    Thanks for your reply John. I'll give what you sugest a try. BTW could the post potentialy be edited manualy so as to OT /OM funtionality or is just flat out not supported within NX? Apologies for the newbie questions. Kind Regards, S 'Yeterday, I could not spell engineer. Today, I are one!'
  2. paragon40

    Lathe Fanuc Post Question?

    Hello, I have a lathe that uses FanucOT ie it uses G32, G76, G92 for threading and U and W for incremental. I created a new post within postbuilder and selected the fanuc generic post as a stating point but this post issues the G33 for thread cutting and G90/G91 for absolute/incremental modes...
  3. paragon40

    Threading Operation with UG-NX6

    Hello All, This is my first post to the forum. Firstly I stress that I am a novice with NX but am making headway. I have am having dificulty with creating a lathe operation for threading. The part is a basic bolt that was designed with the basic primitives and with detailed thread via...
See more

Part and Inventory Search

Back
Top