MY CONCERNS ARE STRENGTH
DO I GET THEN MADE IN
8.8
10.9
12.9
-OR A STRONGER GRADE OF ALUMINIUM
-I WANT IT DONE CORRECTLY
-THEY WILL BE ON A 1.5 TON VAN
I.E. IDEALLY HOLDING UP A 100 RATED TYRE
-I JUST WANT THEM CORRECT - TO GRADE, INDUSTRY STANDARDS
-I KNOW I NEED AT LEASE 10.9 FOR CALIPER...
hello again all, well I had them made, I now wish to have your opinions.
there they are
so i have stock roll sentres, ackerman
basically stock geometry
-my only real concern is fissure strength - if thats what the term is?
do i just have them made in steel?
-the machinist won't do...
I am having machined some custom front hubs
basically to suit a 1975 vw van, so single row taper bearings.
now these are steel, what I am having made are in alloy
they are replicating a porsche stud pattern, the porshe hubs they are replicating are cast alloy
my concerns are, which grade...
