Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by pantr
-
Beginner question cylindricity GD&T
Hi JeSuisBourbaki, Thank you for the reply. The 0,03mm cylindricity tolerance was purely an example. The Ø60 +/-0,02 dimension would give absolute values of either Ø60,02 or Ø59,98. The cylindricity GD&T of 0,03 would mean the entire cylinder can have an unroundness of either Ø60,03 or Ø59,97...- pantr
- Post #3
- Forum: Student Engineer General Discussion
-
Beginner question cylindricity GD&T
Hello, Very beginner question but say I were to dimension an O.D. diameter with a strict tolerance, e.g.: Ø60 +/-0,02. Would it then be redundant to add a, for example, 0,03mm cylindricity GD&T tolerance to this diameter?- pantr
- Thread
- Replies: 6
- Forum: Student Engineer General Discussion
