Recent content by Pachem

Is it possible to use Inventor R11 under Windows 7 ?

to Scott, "manually activate a Config and select hide/show as needed per config" doesn't work for surface bodies. to rfus, Another parts in the assy depend on this surfaced part, so "delete body as suppress" not a good choice. Anyway thanks...

rfus, Is it possible to create Display States in the part? I can't show/hide using Display Plane in the part in SW2006.

Scott, Do you mean that there are different type of surface in SW: surface body & simple surface? I also can't find how Design Table can hide/show surface.

I can suppress/unsuppress any feature "for this configuration only", but is it possible to hide/show a surface "for this configuration only" too?

Is it possible to change hole (dia & callout) in the Hole Wizard (for example from 1/2-13 to 5/8-11) using Design Table (Excel) or API?

I save bodies from multibody part (Base-part with holes + cosmetic threads) as separate parts (Part-1, Part-2 etc). But there are no cosmetic threads around holes in the new parts (Part-1, Part-2 etc). Is it problem with SW or I did something wrong?

Is it possible to automatically turn off non-circular holes in the SW Hole Table?

Yes I tried, but without success. I can't make diff qty of features for diff configurations of the same smart component.

I have a plate with screws as smart components. Is it possible to make diff qty of screws (holes) as smart component in diff configuration?

CorBlimeyLimey, It's OK. I'll wait your response.

CorBlimeyLimey, Yes I know, but it's about Excel-based BOM. Is it possible to do the same in the SW-based DOM?

How to link custom property Detail Number to a SW BOM Balloon? There is faq559-289 about Excel-based BOM, but what about SW BOM?

Try this also: http://www.3dcontentcentral.com

CorBlimeyLimey, Thanks!