Recent content by pabolton

Thanks tmoose there's some interesting information there

In response to David, I have reverse engineered the bearing race, the initial point of the post was to get peoples feedback on whether or not there are any existing standards for the geometric and dimensional tolerancing of the drawings i.e. run-out on the bearing race, whether to define Ra...

In reply to the comments above the bearings are non-standard sizes and the OEM manual allows replacement of individual components of the bearing during overhaul and we can presently buy individual parts of the bearing. I totally agree that replacing the full bearing is the way to go but I'm...

To dinjin, who do you consider to be the "smaller bearing manufacturers"? Thanks

The only reason I'm considering the project is that we presently have to replace either outer or inner races individually as wear dictates during overhaul and the prices/lead times are excessive. I agree with the comments above but just wanted to carry out an investigation into the feasibility...

Yes, I'm looking to get the races manufactured seperately due to requring very low volumes that the bearing companies don't want to deal with

Does anyone know of a good reference for producing a detailed print of a bearing race (outer or inner) for an angular contact ball bearing?

Does anyone know of a good reference for producing a detailed print of a bearing race (outer or inner) for an angular contact ball bearing?