Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ozarks

  1. ozarks

    Tapping 304 ss Thin Walled Holes.

    Thanks Mad Mango; This specific component is used as a "bung" in a furnace assy. The mating (male thread) part is actually a brass nipple of, which explains the need for a low-pressure tight class-3 thread. I truly appreciate your response. In the Ozarks...
  2. ozarks

    Tapping 304 ss Thin Walled Holes.

    I have a small 304ss part that I must thread (tap) on a production basis. The part is stamped out of .050" thick 304ss with a punched thru extrusion that has sidewalls about .100" high. The I.D. of the extrusion is .284" dia. and it gets tapped with a 5/16-32 UNEF-3B L.H. thread. The .284" dia...
See more

Part and Inventory Search

Back
Top Bottom