Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Orbit1000

  1. Orbit1000

    NX 9.O WITH MAC

    HI, Thanks for your comments. I like to check NX 9.0 in MAC enviroment. I have installed X11 and I need to install Open Motif before install NX 9.0. So that I had the problems I posted. I downloaded openmotif2.1.30.tar. I unzip it and then create a directory called "motif" BUT now how can...
  2. Orbit1000

    NX 9.O WITH MAC

    Hi, I would like if NX 9.0 is compatible with MAC IOS 10.9 MAVERICKS. I try to install it and there is a problem of compatibility THANKS
  3. Orbit1000

    help with a part

    Thanks to all for the help. I will study them. Pilot Kleim
  4. Orbit1000

    help with a part

    HI, I'm using NX8.0. I enclose a pdf sketch with 3 channels around a diameter. Someone can help me in drawing that channel? Thanks Pilor Klein
  5. Orbit1000

    Tabular note in NX8

    Hello I have to built a new drawing sheet from the new tools of NX8. First I've created the borders and zones, before using Title Block command to construct a customized title block I draw it by Tabular note. I`ve made four independient tabular note in the same sheet, but that four tabular...
  6. Orbit1000

    Gross Volume

    Sorry, I haven't the advanced Assemblies licence. the piece is not an assemblie, it's all pieces that I'm drawing, one by one. Thanks Pilor Klein
  7. Orbit1000

    Gross Volume

    yes! I mean without bear in mind holes, etc. In others words, I like to calculate the volume of a block that "wrap" the piece. Thanks for your help Pilor Klein
  8. Orbit1000

    Gross Volume

    Hello, Is there a way to calculate in NX 7.5 or NX 8.0 the gross volume of a piece? I don't look for the net volume, I know that Nx can calculate it, but I Have no idea if NX can calculate the gross volume with the maximum dimensions of the piece without count drills, milling, etc Thanks for...
See more

Part and Inventory Search

Back
Top