Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by OpticMech
-
Constrains qeustion - Spheres and holes
Autocol, Thanks, real close too the solution my reps came up with, only I do it all on the base sketch making the right triangle out of construction geometry. I know I should’a posted the answer as soon as I got it, but it was one of those got the answer and ran with it. Regardless, yours...- OpticMech
- Post #6
- Forum: Autodesk: Inventor
-
Constrains qeustion - Spheres and holes
I think I tried every possible tangent combination possible. I had limited success with putting a chamfer on the hole/cylinder (tangent of a cone to a ball), but if the radius of the ball greatly exceeds the Dia of the hole the ball hovers above the pane it should be dropping into. I also tried...- OpticMech
- Post #3
- Forum: Autodesk: Inventor
-
Constrains qeustion - Spheres and holes
I’m new to Inventor, just got Version 6. I am having trouble with a constraint problem. I work allot with lenses, so a sphere locating on a hollow cylinder (a spacer) is a common occurrence, to properly space two lenses. I have not been able to constrain this geometry. I assume the same...- OpticMech
- Thread
- Replies: 5
- Forum: Autodesk: Inventor
