Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by omidfn

  1. omidfn

    How to define hysteresis loop in ANSYS MAXWELL?

    Thank you
  2. omidfn

    How to define hysteresis loop in ANSYS MAXWELL?

    Dear Skogsgurra, Thank you for the offer. I checked that software out and it seemed legit, nonetheless I have to do this simulation with Maxwell, maybe next time I'll give that a try. sincerely
  3. omidfn

    How to define hysteresis loop in ANSYS MAXWELL?

    Dear aussiejohn2, thank you for your opinion. I thought so at first but to examine that I defined a transient BH loop plot to see what happens inside the hard magnetic material as the simulation was being conducted, it appeared that it does not make such an assumption and simply goes up and...
  4. omidfn

    How to define hysteresis loop in ANSYS MAXWELL?

    Dear aussiejohn2, I'm afraid so, the hysteresis motor works on the principle that in hard magnetic matters the area enclosed by the loop is considerable so the energy conserved in the loop could be used to produce acceptable torque so it's imperative that in fact it should be a loop not a...
  5. omidfn

    How to define hysteresis loop in ANSYS MAXWELL?

    Dear Skogsgurra, Thank you for you quick response. Unfortunately, there does not seem to be an apparent way of defining a BH loop as the case for BH curve. Yes there is a look up table and I have tried it but when I enter the values for the whole loop, an error pops up which can be seen below...
  6. omidfn

    How to define hysteresis loop in ANSYS MAXWELL?

    I am trying to simulate an electric motor in ansys maxwell software, but I can't define the whole loop in four quadrants for the material used in the rotor however it is essential to do this since the motor is of hysteresis type and works on the principle of working point moving all around the...
  7. omidfn

    electric motor simulation in MAXWELL

    Hello, I'm trying to simulate a 3 phase hysteresis motor with 4 poles, 36 slots, input voltage peak 220 for each phase, 50Hz, specified dimensions and 0.6 N.m output torque in maxwell transient. The magnetic material used is LNG52 which is also known as alnico600, alnico5DG(ACA52) and alcomax...
See more

Part and Inventory Search

Back
Top