The design intent of this drawing is to say that end surfaces have 6.0mm profile tolerance (+/- 3.0mm).
But the way the designer is trying to convey it is a bit weird. calling out datum targets, these being in several directions, and being features of size... At least I have not seen this done...
Hi Guys,
Thanks for your answers.
I am attaching the whole drawing here. indeed, there is more than one datum target and they are in different directions.
plus, some of them are called out to a Feature of size... is this legal per Y14.5? If so, I guess the pin/hole in the Gage would be the size...
Hello Guys,
I have a question about a drawing sent by Ford to the Fluids Division of my company.
In this drawing, there is a datum target call out at pitch dia of the nut (A1).
The intent is to control the Line to not be either larger not shorter than 3.0mm with respect to its basic/nominal...
Hi Guys,
I have a question, I hope you could help me:
Rule #1 of Y14.5 states that the limits of size of a FOS also control its form (UOS). But what happens when a FOS has only one limit of size? For example, a pin diameter that is called out at 10.00mm Max.
Thanks in advance for your help...
