Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by oldmanneri

  1. oldmanneri

    holes to slots

    thankyou all, I got it to work by mixing and matching all your points and suggestions! thanks!
  2. oldmanneri

    holes to slots

    I am modifying a sheet metal part that someone else created. I want to turn all the holes into slots. what is the quickest most effective way to do this. And yes I am a bit of a newb. I think the guy used the hole wizard to make the holes. I also don't want to lose the X/Y table for the holes in...
  3. oldmanneri

    delete from drawing

    MElam.......THANKYOU! (thanks ctopher also for your advice) locksheet focus did the trick. although i have no idea what it does.....it worked! thanks again.
  4. oldmanneri

    delete from drawing

    When i do that the ellipse disapears along with the rest of the views, all that is left is the title block and junk like that.
  5. oldmanneri

    delete from drawing

    Hi, I'm a newbie. I am working in a drawing and i have drawn and ellipse. But now i can't delete it. Its there in grey, i can't select it. its just there....but i want it gone! i think i drew it in a view and then deleted the view but the ellipse stayed. please advise. thanks. old man neri
See more

Part and Inventory Search

Back
Top Bottom