Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by okumbe

  1. okumbe

    FAbricated Elbow according to AWWA

    Accordıng to AWWA c208 standard, the deflections in the pipe aligment more than 5 degree must be settled with a fabricated elbow. My main problem is regarding the angles up to 22.5 degrees. Because when an elbow is fabricated in a workshop, I will have 3 welding joints along the pipeline(1 shop...
  2. okumbe

    standart for minimum distance of suction intake-bottom plate

    thanks for the reply but I am actually looking for a value that can be used in storage tank design. I mean API 650 gives a value such as the minimum distance between the suction intake and botoom of the tank should be 1 times the diameter of the intake nozzle for sump draw-off. But nothing is...
  3. okumbe

    standart for minimum distance of suction intake-bottom plate

    Hello Friends I want to learn if there is a API standard that gives information about the minimum distance between suction pipe intake and the reservoir bottom. Thanks
See more

Part and Inventory Search

Back
Top