Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by obby65
-
Feature library basics
To create a feature library of basic shapes (obrounds etc)for sheet metal should i create these in parts, draft or sheet metal and saving as a dwg file ?- obby65
- Thread
- Replies: 7
- Forum: Siemens: Solid Edge
-
St3 no alignment lines ?
When i draw a square plate in sheet metal and select a hole to be placed on to the selected plate the hole just follows the cursor around the plate, why aren't the green alignment lines or cross hairs located through the cursor automatically turned on so I can dimensionally place the hole.? I am...- obby65
- Thread
- Replies: 2
- Forum: Siemens: Solid Edge
