Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by NXuser311

  1. NXuser311

    NX2027-Center of mass in information window

    Ya I know how to put the associative point there already, it's more of a data not being consistent between dialog boxes problem. Especially when I need to export the data from the information window specifically. Appreciate the response though. I'm pretty sure it's either a setting somewhere...
  2. NXuser311

    NX2027-Center of mass in information window

    2027.3701
  3. NXuser311

    NX2027-Center of mass in information window

    Even with your WCS set to some place random out in space? If it's absolute then ya they transfer over the same numbers, but as soon as you move it off absolute then they change between screens for me.
  4. NXuser311

    NX2027-Center of mass in information window

    Using measure-object set to get the center of mass in relation to the WCS. With the reference CSYS set to WCS the pop up window will show the correct coordinates for the COM in relation to the WCS but when I click OK to send results to the information window the COM will say (WCS) next to it but...
See more

Part and Inventory Search

Back
Top