Thank you for this suggestion, cyclecyko. I had a look on Amazon.com. I feel this book describes the machining of small series or prototype cylinder heads and is rather intended for "serious enthusiasts". Am I correct? What I am interested on is rather how big volume cylinder heads are produced...
Thanks.
I am particularly interested in knowing in which order the machinings for the valve guides, valve seats and control cuts are performed.
Any info concerning this point?
Can somebody provide information about how cylinder heads are machined?
I am above all interested in the machinings and operations required to install the valve guides, valve seats, control cut and so on.
I understand that the way this is done may depend on the OEM considered but is there an...
