Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by not_a_pro

  1. not_a_pro

    eigenvalues reactor

    Hi Anime A, this depends on a lot of factors. It would be helpfull to have some further information like the boundary conditions of the besement, the mass of it and the stiffness in comparison to the reactor. For example, when the stiffness is much lower than the reactor stiffness, which would...
  2. not_a_pro

    Power Transmission Ideas for a Coaxial Wind Turbine

    I think the best solution would be a differential like the ones in cars. There you can transmit the power from two coaxial shafts, which rotate in the same direction but in different speeds, to one shaft which is perpendicular to the other shafts. The only difference would be the direction of...
  3. not_a_pro

    APDL slows down

    I have tested it and the used RAM does not increase while running the code. Any other thoughts?
  4. not_a_pro

    APDL slows down

    Hi everyone, I have the following problem: When I start a calculation with ANSYS APDL from some code, it starts quite quick and slows down a little bit while calculating. I see that at the speed in which it reads some scalar parameters / the speed in which the read scalar parameter are printed...
See more

Part and Inventory Search

Back
Top