Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations 3DDave on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Noids

  1. Noids

    Inspecvtion Opening Does Not Meet Code

    No it does not meet code. It is not part of any customer spec. I am responsible for vessel design & checking. Thanks for the reply.
  2. Noids

    Inspecvtion Opening Does Not Meet Code

    Hello, Is there any way to justify to the customer the use of a 2" long weld neck as an inspection opening on a 24" OD vessel? This design slipped through the cracks. It is built & installed on the skid. It would be very costly at this point to repair. The local jurisdiction & the AI will...
  3. Noids

    Questions Concerning UG-84 Base Materials

    SnTMan, thank you for your response.
  4. Noids

    Questions Concerning UG-84 Base Materials

    Could we say that an impact test specimen consists of the base material, the HAZ & the weld? Also, if a vessel is built to ASME Section VIII Div.1, the impact test requirements to be met are in Figure UG-84.1? For the example above in Figure UG-84.1, 2.25" thk plate (SA-516-70N) the energy...
  5. Noids

    Questions Concerning UG-84 Base Materials

    Please help me understand the following: For UG-84(g)(5), How are the impact test energy values established for the "base materials"? Does "base material" refer to the impact test specimen energy value requirement from Figure UG-84.1 that is to be met? Or is it the energy values of the...
See more

Part and Inventory Search

Back
Top Bottom