Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by NobleEngVybes
-
FBE roughness and degradation with time
Hi All, Anyone have any knowledge about typical internal FBE coating roughness values and whether these values degrade with time? Thinking of a water injection line service here which carries some TSS. I am using a typical roughness value for FBE of 0.005mm in hydraulic calculations, but not...- NobleEngVybes
- Thread
- Replies: 4
- Forum: Pipelines, Piping and Fluid Mechanics engineering
