Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by nickstevens

  1. nickstevens

    Sheet metal transition bends

    I have a question regarding sheet metal. I'm trying to bend half the edge of a piece of sheetmetal so that half of the edge is bent, then there is a transitional bit the the edge becomes straight. I know that I am supposed to use Bend Angle w/Transition but i can't seem to get it to work - i...
  2. nickstevens

    Sheet metal tutorial

    I have a question regarding sheet metal. I'm trying to bend half the edge of a piece of sheetmetal so that half of the edge is bent, then there is a transitional bit the the edge becomes straight. I know that I am supposed to use Bend Angle w/Transition but i can't seem to get it to work - i...
See more

Part and Inventory Search

Back
Top Bottom