Hi to all,
I'm about to design a pressure vessel (VIII-1) which his service have a low concentration (3%) of hydrogen. Material selected is 316L for the design pressure of 500 psig (-20F to 140F). Is there any restriction for design and fabrication?
-reinf. pad not recommended?
-full...
roca,
from 600 psi and higher, use as much as you can. from my experiences, it could save 1/8 to 1/4 in. of thk at 650 to 1200 psi in VIII-div.1. i would do both calculation UG and App. and code case to compare each situation. like the instructor of asme VIII-div.2 said to his students, it...
Joe,
it is not necessary to have ASME code stamped, just follow the code CSA B51 (available in english)who refered to ASME code with some particular requirements.
Hi to all,
We want to use the plate SA-414 Gr. G in a pressure vessel under cyclic reaction due to pressure. The vessel will be done according to ASME Section VIII div. 1. To meet UG-22 (e) requirement, we will do a design based on fatigue analysis according to ASME Section VIII div. 2...
need advise to calculate custom made elliptical manhole cover and ring thickness as per sect.viii div.1. what paragraphs of the code should i based on?
