neroverdi41's latest activity

When I give it as volumetric inlet and pressure output, the inlet pressure starts to rise to very utopian values and it gets ridiculous...

Well I estimate your actual velocity in the 16" pipe is only about 5m/sec at 37 bar at 100,000scm'hr. That's pretty slow and for a...

The 10,000 sm3/h figure seems more reasonable for a low flow scenario, and if that is the case your valve might not be over sized. The...

the customer asked for a maximum flow rate of 20 m/sec. he said that was important for him. how did you calculate the speed?

Hello; the parameters required from a control valve are inlet and outlet pressures, flow rate and temperature. when analyzing I can...

As a result of my analysis, when I gave 37-36, ie dp=1 to the inlet and outlet, the flow rate of the valve was 10000. the desired flow...

My maximum conditions are as follows: pipeline=16” p1=37 bar p2=36 bar Q=100000 sm3/h T=15 C Vmax=20 m/sec I chose 2 lower ones as an...

I work for a supplier but why not use the fisher calculator? I don't understand. there are a lot of cv calculators on the internet and...

my friend, the information has been updated. Pipeline=16” p1=82-36 bar p2=66-36 bar Q=10,000-100,000 sm3/h T=15 C Vmax=20 m/sec the...

Yes, I am working. customers usually give inlet and outlet pressures as a certain range. For example p1=75-35 bar p2=68-35 bar what...

My friend, I don't quite understand what you mean, forgive me. parameters: p1=86-36 bar, p2=86-36 bar, q=10.000-100.000 sm3/h t=15 C...

According to your estimation, what is the reason why the pressure at the inlet according to the maximum is lower than the inlet pressure...

Hello I need to make Axial Control Valve sizing for a line with a size of 16”. Parameters: P1=82-36 bar P2=82-36 bar Q=10000-100000...