1. If an undrained sloped stability evaluation indicates acceptable safety factors for full loading, would measurement of pore pressures beneath an embankment over soft clay
be necessary (from a theoretical perspective) to avoid high PWP buildup leading to a failure?
2. What is a good...
Assuming no freeze/thaw or expansion of bedrock issues, is there any issue with placing a slab on-grade directely on a granular bed of 4-inches directly over limestone bedrock. Assuming the bedrock is relatively level.
Intuitively, I can't envision there being an issue with this; but would...
I don't think blasting would be an issue. It's a relatively remote area (more remote than I've seen blasted in the past).
I'm more concerned that it won't be allowed (for whatever reason the Owner provides) and change orders follow; due to contractor claims of difficult 'mechanical excavation'.
I am involved in a project where the Owner would like to omit drilling and blasting as a method for rock excavation; however, rock excavation will
be required for foundations and utilities for numerous(>30)residential structures on shallow foundations (no basements). The site is relatively...
Is there a way to utilize unit skin friction values (calculated from a load test on H-Piles) for use in pipe pile design?
Seems to me that this would not be possible due to the skin-soil-skin-soil (assumed plugged) behavious of an H-Pile; but wanted to hear from others on this.
When calculating foundation settlement in moist (unsaturated) clay, do DMT methods (eg. Schmertmann, 1986) consider the effects of possible future saturation?
We received a CBR test report indicating a CBR of 92 (0.1 in. penetration) for a silty sand (Max. Dry Density 132.1 pcf) with no gravel. The reported Dry Density Before and After Soaking was 129.4 and 129.6 pcf, respectively. The uncorrected CBR was around 40 (0.1 inch penetration) and after...
I understand which value would be used in the analysis. I'm just trying to figure out the proper protocol for reporting strength values.
So, if you reported an undrained strength the same as the drained strength.....would that technically be correct?
Or should you just not report an undrained...
For the purposes of a slope stability analysis (static case only), would a free draining material (eg. clean gravel and/or sand)
have an undrained strength? I often see in reports that the undrained strength is equal to the drained strength.
For example, the following values may be reported...
Typically, average vertical 'uplift' gradients are limited to about 0.5 near the landside toe of an embankment levee or dam; and where the
phreatic surface exits to the ground surface. What is the protocol for determining exit gradient if phreatic surface is buried; such that
it can be compared...
A soils testing firm is suggesting that CD testing is not required for a stability analysis of a silty clay compacted embankment soil; rather just CU(bar). Indicating that CD testing is rarely performed. Is there a justification for not performing CD testing for drained conditions on compacted...
Looks like there are several versions of the ENR formula.
Some which calculate Qu and some which calculate a 'safe load'
which I assume is Qu.
What does the original formula calculate?
An old dwg prepared by USACE references the following:
'Min. length of round timber piles 30-ft; or driven to a firm bearing so as to support a load of 25 Tons, calculated by the Engineering News Formula.'
My question is whether or not the pile load referenced is allowable or ultimate. My...
Assuming a clay levee over an impervious top stratum overlying sand and fully loaded; is there a difference between the factor of safety against piping (FS=ic/i) at the levee toe (landside)
versus the factor of safety against uplift (landside toe)? Are these terms essentially the same phenomenon?
