I'm looking for guidance on the acceptable scale range of a load cell or Dynamometer when used for load testing.
for example for some torque wrenches, torquing is only accurate to values between 20% and 90% of the scale range.
is there any guidance for load cells / dynamometers? Is there a...
sure,
open ocean water
valve body - CUNI
valve stem - NICU
valve seat and stem seals- PTFE
Thanks again for your help,
I've seen some older threads that stated corrosion rates for pitting at 1 mil depth per three months does anyone know were that might have come from.
Thanks for your input unclesyd,
What do you think about imposing an operational requirment, like cycling the valve after system operation to release the seawater upstreem of the valve?
Would that improve the situation much?
I have a question/problem i hpoe someone out there can help with.
Due two many breakdowns in comunication a 316 ball has been installed in a ball valve which is in a sea connected system where a Ti ball is specified.(seawater is not continuiously in the system but there is usually some amount...
