Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Nathan448
-
Tolerancing a 'V' block
Hello is this correct? I would like the H7 holes to hold dowel pins which are used to align the V block, which must hold a shaft perpendicular to them. I am concerned I have not placed a datum onto anything 'real' although the machinist would make a shaft at the reference diameter to check the...- Nathan448
- Thread
- Replies: 1
- Forum: Drafting Standards, GD&T & Tolerance Analysis
