Recent content by Nate360

Is there a process/document/spec to reference when annodizing aluminum? In particular, aluminum with a gold chromate conversion or clear irridite/clear alodine finish. Much thanks, -Nate

For a standard, 15A, 250V receptacle, NEMA rated, are the termination screws always brass? Is there a standard that defines this? -Nate

Yes, Pop (r) is what I would use. A closed-end style rivet.

Thanks Adrian I am ok with grip range and pull out strength. Mercury is out because our shuttle is in the shop. The circus left town, so there goes my elephant. Luckily, these plastic connectors are securing wire assemblies! I will perform a shake test to thoroughly investigate the connection...

Can anyone provide any information on using a rivet (either aluminum or stainless) to attach a plastic connector to a piece of sheetmetal (.080 aluminum)? Is this an acceptable practice?

Can anyone assist with a PCBA torque inquiry? A #10 pan head screw (.190 head OD) is being used to mount a clip. The board is 0.063" thick. I would like to know the point at which the board begins to cold flow (under what force). I am trying to set the proper torque for mounting this clip.

What type of 3D software do you have access to? I know that AutoCAD 2000 has standard symbols and parts that you can .dxf into 3D software. X-)