"Preliminary Design Processes" authored by Herb Rawdon in 1949 is often referenced by other authors. This document is apparently archived in the Wichita State University Special Collections (# Series 2 , Box 2 FF2) and is listed as being not for distribution. Can anyone advise whether and how a...
Has GA(W)-1 2D data been published and is it available.
I am looking Cl, Cd and Cm vs alpha at 0, 10, 20 and 40 degrees Fowler flap angle all at RE's 2, 4, 6 and 8x10*6 and std roughness. Many thanks.
If anyone has new or used copies of any of the following texts I would be most grateful if you would let me know a URL to get them:
1. "Airplane Performance, Stability and Control" by Perkins and Hage.
2. "Fluid Dynamic Drag" by Hoerner
3. "Aircraft Design" by K. D. Wood
4. "Design of Light...
Re heat damage to al alloy structure such as caused by a leaking turbo charger exhaust or APU. Can anyone direct me to procedures for conductivity testing with and without hardness testing backup. Considering the likelihood of such damage occuring, it is surprising that such info is not readily...
Brief notes for repairing structures:
1. Maintain original strength. Avoid using up any of the original MS.
2. When possible and practicable avoid using blind fasteners
3. Always replace solids with solids unless access is against you.
4. Consider installing access panel to permit installing...
Can anyone advise who is the vendor for the following hose part number listed in the Hiller 12E IPC:
"HS952LD0272 interchangeable with 601002-12D-0272".
These numbers don't show up in my Aeroquip and Stratoflex catalogs.
Many thanks,
Bob Naylor, Aero Design Group, Queensland...
