Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by mwallace010
-
440C stainless steel issues
Material was bought as ground rod bar Ø.3125 I have not removed any material for the od just milled the ends. I believe it is some sort of inclusion it will follow the whole length of the bar 6ft. Never seen material pull off like this- mwallace010
- Post #3
- Forum: Metal and Metallurgy engineering
-
440C stainless steel issues
I am using some round bar 440c SS and keep running into issues with the material delaminating or tearing out. has anyone seen this before or know what would cause it. When milling or sawing a chip will tear out and i can continue to roll it down the part. Thanks for any advice- mwallace010
- Thread
- Replies: 6
- Forum: Metal and Metallurgy engineering
